Walls preprocessing
1. The walls must be clear of any pollutions like wallpapers, paint spots, dirt, dust etc.
2. The walls demands to be flat. After cleaning, it is necessary to putty the cavities and remove the ledges on the walls.
3. Hygroscopic surfaces and surfaces which absorbs moisture (gypsum, wood, plywood etc.) are must be processed with special waterproof substance on purpose of avoiding the mold and
other defects which appear due to extra humidity.
4. After the surface gets dried, the dust and other kind of pollutions must be removed from the surface. Then apply the deep penetration primer on the surface.
5. The surface must be dry, flat, solid and tough.
6. Before to apply the wallpapers make sure that surface is completely dry.
7. If the rules and temperature requirements for wallpapering are violated, the rolls can shrink by about 1-2 mm. Therefore, we recommend painting the wall in the same color as the
background before wallpapering. Thus, with a slight shrinkage of the wallpaper, the gap between the rolls will not be noticeable. Note!!! Walls for gluing peel and stick wallpaper should only be coated with water-based paints. Other types of paints are not suitable for this type of wallpaper.
Important!
-
The wallpaper is cut for gluing butt-to-butt. Before gluing, make sure that adjacent wallpaper rolls are joined together. The allowable deviation in the figure may be 1%. This deviation can be eliminated during the wallpapering process because they are made of elastic material and can be stretched if necessary.
-
It is best to smooth the wallpaper with a rubber roller. We do not recommend using a spatula and a wet rag, so as not to damage the wallpaper.
All processes must be carried out only after you make sure that the walls are sufficiently prepared. Peel and stick wallpaper does not require drying. Therefore, the speed of decorating a
room using this material is as high as possible.
Getting started:
Kindly ask you to read first before start the process!
1. Check the integrity of containment of the parcel.
2. Check out if wallpapers, which arrived to you, match to the wallpapers you ordered.
3. Expand the wallpapers like joint to joint on the floor.
4. Check out if the wallpapers include any kind of damage or any kind of defects.
5. If any kind of defects are spotted, please contact to us.
6. Before sticking the wallpapers leave them in the room where they must be applied for about 2 hours long.
7. We recommend doing all the processes at 18-25 C (64-77 F) temperature in the room.
8. Make sure the walls are not too cold. If the rules and temperature requirements for wallpapering are not observed, the rolls may be compressed by 1-2 mm. Pay attention to this!!!
Wallpaper sticker scheme
Set the vertical reference point on the wall to stick the wallpapers strain.
Assembly the wallpapers on the floor to check out how does completely painting looks like. Set the numbers on the backside of wallpapers and then stick them on the wallt.
The wallpapers are stuck on wall like joint to joint. Each canvas of the wallpapers stick to previous one to complete whole painting. Stick the first canvas to the wall along the vertical reference point.
The canvases are must be smoothed and rolled with a dry and clean rubber roller.
Do not allow folds and any kind of damage to appear on the wallpapers during the process.
Excess ledges of the wallpapers are must be carefully cut with a help of keen steal knife or any kind of keen device. Avoid an excess pressure on the wall to don't damage the surface of the wall.
The result will be ideal if the installation was done accuracy.
